Need (very) short run of 3 (very) small parts.

[thor2k]

We are at the prototype stage on this wrist watch design, consisting of case, back, band (2 identical parts) for a total of 4 pieces.

We just need 4 sets machined to see if our "fit and finish" is on course, from either silver or 6061 aluminum.

We have Solidworks and IGES files of the design, ready to go.

If the project is wildly successful, no more than 1,050 sets would be ordered, in short runs of 50-100 sets each.

Chomping at the bit, right?

Please let me know of your interest, capabilities and willingness to sign NDA.

Regards,

Jay

[annoying]

You can sure bet aluminum would be your better choice for prototype. Silver would sure get expensive.

I'd be happy to have a look at what you need, and NDA is no problem at all

If you'd like, send info to ironman34@msn.com