GE 1050 controller on Behrens Turret Punch

[TZak]

Not sure if this is the correct place to post, but here goes.

I am trying to get an old GE Century Mark 1050 controller working on a old Berhens turret punch. I have a BTR for the machine however I only have the actual tapes to load the machine parameters and the MSD ( but they are very delicate). The problem is the reader is not working properly and thus I can't load the files into the control.

My question is does anyone have the parameters of the tapes for this machine and controller in a digital format. Then hopefully I can load them via our BTR, if thats possible.

Hopefully there is someone who can help out.

Thanks

[DSIF]

Sorry dude. Hands down the GE 1000 series controls were the worst ever made. 30+ yr old technology that sucked back then.