Nardini Fast Trace fanuc 20-T Edit Mode

[Eric05]

I have a Nardini Fast Trace with a fanuc 20-T control and when I reference the lathe to home the machine will no longer allow the edit, mdi and other modes. They are available before reference. We bought this machine and the previous owner put a new oiler on and I think they messed up a wire or parameter setting. It will run with the simple guidance mode with a small 5 point program or in manual mode but not in mem mode.

Thanks Eric

[nicoledc109]

Thanks you for the post.
Hi guys, Im a newbie. Nice to join this forum.

__________________
Watch The Expendables Online Free

[metlcutr55]

Eric, i also have a nardini fast trace with 20-t, my knowledge of parameters, blah, blah, is poor but mine is set up and running well, pm me if youve not resolved this yet, at very least i can help compare my properly running machines parameters and settings with yours

[Eric05]

Update: We have contacted Fanuc USA and they gave us some info and we will try looking at the PMC Ladder logic display and see what we can find out with a friend who is an electronics guru. Also a parameter setting as well.

Eric

[Eric05]

Update: Well we have discovered a missing battery (one of two) and have decided to check this issue first. It implies that the reference may not be working correctly with out it and a proper re-zero of the machine.

Eric

[Eric05]

Figured out how to send a program as 7999 which is what the teach program uses. If I send a program over and then reference it then I can run the program. Now all i need is a Gibbscam post processor for the nardini fasttrace and FANUC 20-t controller

Eric