Newbie What should I use to cut Depron(foam).. - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Material Technology > General Material Machining Solutions
Newbie- What should I use to cut Depron(foam)..

General Material Machining Solutions Discuss Material Machining Problems and Solutions Here.

This forum is sponsored by:

05-15-2009, 08:42 PM

libory

Join Date: May 2006

Location: UK

Posts: 5

What should I use to cut Depron(foam)..

permalink

Hi, I finished my CNC and it works fantastic. Now I have the tool... and I would like to cut Depron (foam) but wich tool-head should I use to cut this material....

I tried with a normal drill head of 2 mm diameter... it is ok but I don't think is the right tool for this job. Where could I have some information about wich head is made for??

Any help please!

Thanks.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cutting Thin Foam (Depron) please help!	adbradley	CNC Wire Foam Cutter Machines	6	12-18-2008 03:02 AM
Milling Depron Foam	flyingmike	Parts for Radio Control Models	6	12-04-2008 09:23 PM
Depron laser cut?	thom33it	Laser Engraving & Cutting Machines	6	11-05-2006 11:59 AM
Molding Depron	CNCadmin	Vacuum forming, Thermoforming Etc	5	10-30-2006 09:40 AM
CNC Router for 1/4" Depron foam	CDignition	DIY-CNC Router Table Machines	2	12-30-2004 06:36 AM

All times are GMT -5. The time now is 06:48 PM.