| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Material Machining Solutions Discuss Material Machining Problems and Solutions Here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-04-2009, 07:02 PM
| |||
| |||
I have a friend that needs holes drilled in geode stones for jewelry. She has burnt up bits trying with a dremel. I figure the rpms were to high. She is going to bring over some diamond bits for me to try on my bench top milling machine. Any advice on speeds or approach is appreciated.  |
|
#2
02-04-2009, 07:12 PM
| |||
| |||
| Has your friend gone to someplace that supplies lapidary equipment? It should be possible to get advice there; rockhounds do this kind of thing all the time.
__________________ An open mind is a virtue...so long as all the common sense has not leaked out. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Drilling with V22 | orizaba | BobCad-Cam | 2 | 12-26-2008 04:04 PM |
| Problem- drilling | Goran P. | Fanuc | 7 | 07-15-2008 08:53 AM |
| Drilling on the TL-1 | DivMechDes | Haas Mills | 9 | 11-02-2006 12:46 PM |
| drilling and drilling cycles tutorial | wmorre | General Metalwork Discussion | 0 | 10-18-2006 06:30 PM |
| PCB Drilling | drk | Carken Products (Deskam, DeskCNC etc) | 3 | 12-14-2004 08:27 AM |
| | |
Linear Mode
