| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Material Machining Solutions Discuss Material Machining Problems and Solutions Here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-27-2008, 12:04 PM
| |||
| |||
Hi ! I have been testing my tabletop CNC machine. It is intended only for 2Ply vinyl engraving. I have asked around but have not got any answers that I am happy with. I use °30 cutters that are 3.175mm in diameter. The endpoint is 0,2mm. Can any one tell me the right RPM to use and travelling speed on X and Y axis ? I have tryed quite a few speeds but sometimes the cut is not clean enough and in other cases the cutter collects debry on the bit and destroys the vinyl surface. Help would be very much appreciated. I really need a buddy with good knowledge in those matters. Sincerely Einar  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ZERO SPEED, anyone know? | JohnnyTurn | Mori lathes | 4 | 02-25-2009 03:10 PM |
| The Widgitmaster's Travelling CNC Medicine Show | BobWarfield | DIY-CNC Router Table Machines | 7 | 03-24-2007 11:38 PM |
| BPSeriesI / Centroid control- Spindle speed all out of whack with speed dial? | peter.blais | Bridgeport and Hardinge Mills | 9 | 08-08-2006 03:29 AM |
| travelling salesman | ghyman | Visual Basic | 7 | 10-27-2005 05:16 AM |
| min speed exceeds max speed for axis "x"? | ljoe1969 | TurboCNC | 4 | 01-19-2004 07:49 AM |
| | |
Speed (RPM) and travelling speed. 
Linear Mode
