Feed Rate & RPM to cut Ebonite Material ?? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Material Technology > General Material Machining Solutions
Feed Rate & RPM to cut Ebonite Material ??

General Material Machining Solutions Discuss Material Machining Problems and Solutions Here.

This forum is sponsored by:

11-18-2008, 07:42 PM

Calico

Join Date: Feb 2005

Location: Indonesia

Posts: 221

Feed Rate & RPM to cut Ebonite Material ??

permalink

I have Ebonite small block material.
I have 4 flute 10mm diameter EndMill Flat.

what's the feed rate and RPM to cut this with CNC Mill machine ?

thank you

cal

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Feed rate for 5/8-18 tap	Eagle View	General Metalwork Discussion	2	09-24-2008 09:25 AM
Need Help!- Feed rate Ovverride also Increases rapid rate.	Korellibopper	Machines running Mach Software	1	01-30-2008 05:37 PM
Feed Rate and Spindle Rate for this cut?	DroopyPawn	General Metalwork Discussion	20	11-21-2007 11:12 PM
C & Z Feed rate	rfstar	G-Code Programing	7	06-22-2005 12:38 AM
How can I up my feed rate ?	ynneb	DIY-CNC Router Table Machines	7	07-12-2004 09:40 PM

All times are GMT -5. The time now is 06:46 PM.