| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Material Machining Solutions Discuss Material Machining Problems and Solutions Here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-05-2010, 03:57 PM
| |||
| |||
I need some help holding a 125 finish thru 3" of 4130 with a tol of .500 +.003/-.001 also need to take into account .0003-.0005 plating per side so i need straightness as well. Also its 300+ parts so something that doesnt take 10 mins a part.  |
|
#2
04-08-2010, 08:10 PM
| |||
| |||
| Have you considered roller burnishing? Cogsdill makes them as well as others. Dick Z add: www.cogsdill.com
__________________ DZASTR Last edited by RICHARD ZASTROW; 04-09-2010 at 01:36 PM. Reason: add: |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fadal 4020 surface finish problems. Help! | duane999 | Fadal | 14 | 05-12-2010 08:22 AM |
| problems with finish on MDF (wrong feed? speed? chip load?) | posix | WoodWorking | 10 | 12-26-2009 01:44 AM |
| Finish problems | Delw | Haas Mills | 27 | 06-28-2009 12:22 AM |
| Problems with rough finish | 44-henry | Tormach PCNC | 11 | 06-02-2009 12:43 PM |
| micro boring 440c = finish problems | Fala_Man | Hard and High Speed Machining | 1 | 08-22-2007 11:25 PM |
| | |
Linear Mode
