I feel for you toolman, that is very bad luck and pretty much the opposite of what I have been experiencing. I just posted a photo of my electronics innards and they were very tidy.
I wonder how the lasers get to hurricane, E.g. fully assembled or electronics in boxes and installed in the US. Yours and mine look like they came from different companies which is why it made me think maybe hurricane added the boards and then forgot?
Who knows, at the very least if it was done at G.Weike it should not have passed the QA applied in the US.
Hope you get it all resolved.
Seems the problem is now fixed.
I went thru, reseated the drives( the connections themselves) found a couple of loose wires, and reinstalled the software and drivers.
So far so good.
And will also mention, that Hurricane has gone beyond what I would consider normal. Last communications with John( the owner), he was very apologetic about the troubles, and has offered and put me down for a new laser tube, when it is needed.
A+++ there.
Just to update alittle more. Have been runnning for last couple of days with no problems.
The machine seems to be working fine now. I am liking what i can do with it.
well thought I had it solved. Ran pretty decent for awhile.
Back to losing steps again. Almost sounds mechanical this time.
When engraving( no speeds over 400) it will be running and you can hear a "clunk". And well after that it had missed steps and scrapped a part.
Call another $45 in materials and lost time down the drain.
Need to figure this one out this time.
Here we go again,.
Anthony,
Larry will be calling you in a few minutes. Always feel free to call us for a quick response. we are here from 9am-6pm PST and by email most always.
Call us at 855-552-7377 for anything.
John
Posting Permissions
LinkBack URL
About LinkBacks
