LinkBack URL
About LinkBacks
I dont know the laser side very well but I do know the FNC5 control .
| | |
Do any of you guys know anything about Behrens lasers. I have a cb2500 with and fnc-5 control techniques controller. And i need to find some support.
Thanks,
I dont know the laser side very well but I do know the FNC5 control .
What Im Trying To Do Is Make A Program For 1 Part And Nested It On A Sheet Like A Mazatrol Control Do You Know If This Possible. Thanks
Sorry, I dont know the programming. I can support the FNC5 technically.
Hello!
I connected CNC Arrow 750 Machine with FNC-5 to PC computer. What software I have to use on PC computer to set up transmission with this machine?
Thanks for answer.
Greetings.
i use machine talk. If you need all the specs to punch into your dnc software i have it
Hi
Hi, we have an old Behrens as we are about to dump, it is a combined laser Punching
Resonator is ok management is from General Electric Sentury 2000 all BUB to bio card is ok. After built new type servo amplifiers. Our dialogue is hosted by Jørgen Hansen from Copenhagen. A very clever man. Check with him maybe he can help, then you also have Wolfgang Walle from Germany.
Is there anyone who is interested in old **** so get in touch. sell everything cheap.
Behrens, Laser Punch, Rofin Sinar Laser. punch tools most part new, something old.
Hi
Hi, we have an old Behrens as we are about to dump, it is a combined laser Punching
Resonator is ok management is from General Electric Sentury 2000 all BUB to bio card is ok. After built new type servo amplifiers. Our dialogue is hosted by Jørgen Hansen from Copenhagen. A very clever man. Check with him maybe he can help, then you also have Wolfgang Walle from Germany.
We just purchased a Behrens laser CB2500 at auction, it came with cbcadcam software for programming. We have all the original 3.5 floppies for software, but it did not come with the dongle to run the software. Does anyone know where we could purchase a dongle for this software or by pass it. I tried contacting megacad that produced the software for Behrens but no reply yet. I am asuming they don't support the software anymore. If not could anyone recommend a suitable inexpensive software for the Behrens laser, needs to interface with FNC5, I have all manuals, PLC, and CFG files
Dear FNC5Behrens,
I am trying to find a programming manual for the FNC5 control and would be very grateful if i could get a copy if you (or anyone else) have one.
Many thanks, simon (at) willans.com
Posting Permissions
| | |
