Results 1 to 2 of 2

Thread: Fireball V90

  1. 02-03-2010, 01:20 PM #1
    BAM
    BAM is offline
    Registered
    Join Date
    Dec 2004
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Question Fireball V90

    Iam new to cnc I just received my Fireball V90 I installed the RBX-RF Isolated parallel port breakout board I would like to install an E Stop and limit switches does anyone have a diagram of the connections?

  3. 02-08-2010, 09:50 PM #2
    Jesse B
    Jesse B is offline
    Registered Jesse B's Avatar
    Join Date
    Aug 2009
    Location
    Canada
    Posts
    392
    Downloads
    0
    Uploads
    0
    Attached is an image from www.probotix.com to wire up their interface board.
    Attached Thumbnails Attached Thumbnails Fireball V90-3-axis_sidestep_wiring_dia.v2.jpg  

« Sensors selection | LMD18245 picstep need help »

Similar Threads

  1. probotix / fireball v90
    By diegomonzon in forum Spanish CNCzone
    Replies: 20
    Last Post: 01-17-2011, 04:17 PM
  2. Sable 2015 VS FireBall V90
    By PunKidd in forum Want To Buy...Need help!
    Replies: 43
    Last Post: 08-18-2010, 07:28 PM
  3. Fireball V90 CNC Router Assembly
    By abbtech in forum Videos
    Replies: 0
    Last Post: 04-29-2009, 02:58 PM
  4. Fireball CNC ? ? ?
    By scratch_6057 in forum DIY CNC Router Table Machines
    Replies: 15
    Last Post: 11-03-2007, 11:21 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.