Universal motor controller

[Drools]

I have been looking for some way to control my PC 9690LR router and I ran across this article.
http://www.siliconchip.com.au/cms/A_111129/article.html
It is written for 230VAC mains and I was wondering if it would work on 110VAC mains? I have not seen the whole article as I would need to pay for it.

[Al_The_Man]

You should be able to get plenty of Triac control circuits out there, many by Component manuf.
http://www.educypedia.be/electronics...torcontrol.htm
There is one included here around the TDA1085 which if you put a simple pulse detector on the motor you have accurate speed control.
Al.

[Drools]

I have been looking for a complete circuit based on the TDA1085 but I'm unable to find one with all values marked.

[Al_The_Man]

http://www.onsemi.com/pub_link/Colla...TDA1085C-D.PDF
I have one from a T.M. motor circuit I could PDF.
Al.

[Drools]

Thanks for the help Al. I'm interested in the TDA1085 but I would have to figure out a way to add a tacho generator to my PC router which may not be easy.

[Drools]

I ended up purchasing a C29 board from CNC4PC.
The C29 is just the board with connectors you supply the case. I used an old PC power supply shell, not a standard ATX power supply. I hooked an 5k pot to the analog inputs and tested the unit with my hand drill. It works as advertized, once I get the mount for my Porter Cable made I will hook it up to Mach3.