Problem- Z axis going in wrong direction

[erkiwi]

Hi.
I have just finished my cnc machine,I had all the electrics wired up on a board outside the machine to see if all the stepper motors ran in the right direction all OK,I have now rewired them inside a nice control box but I find that the +Z axis runs in the -Z direction,before I start pulling things appart do I have the step and dir wired arround the wrong way at the breakout board or driver or do I have my wires crossed at the stepper motor,what should look for first,all the other axis seem Ok.
Regards Eric

[bill south]

Good Morning Oz;
If you are using Mach as your control software, go to config/homing/limits and reverse the z axis. This will reverse the direction for ya.
Bill