| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-20-2009, 11:51 AM
| |||
| |||
I have a Proview monitor and when I power it up the screen only stays on for about 5 seconds and the quits. I did change all the capacitors on the board the has the plug going in. I did try the monitor on other computers and the problem was the same. I was not sure if the transformer might be bad. I did check the voltage on the pins and it did not match what the output. The +6v and the +14v both gave me a reading of 9 volts. The board was made by Mirage Electronics. The information on the board is: PI-190DTLB revA 200-000170DTLBH version:A Any help would be great. I did call Proview and they were not much help. They wanted me to send it to them to look at for $150 plus extra for parts. I told they guy I could buy a new on for alot less. Thanks Joe Last edited by jguerrera; 10-22-2009 at 08:28 AM.  |
|
#2
08-23-2010, 09:28 AM
| |||
| |||
| please check is website relay on you board http://www.badcaps.net/forum/showthr...972#post119972 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LCD Monitor | Dyad1 | Fadal | 25 | 10-14-2011 05:54 AM |
| HL-2 monitor very dim | 11toma | Haas Lathes | 2 | 08-14-2009 10:17 PM |
| Haunted monitor ? | greybeard | CNCzone Club House | 56 | 08-14-2008 02:33 AM |
| monitor | rusticr6 | Haas Lathes | 7 | 10-24-2007 07:06 PM |
| monitor | CASTLEVILLE | Bridgeport and Hardinge Mills | 8 | 10-10-2007 06:37 PM |
| | |
Proview PL926Wsi monitor 
Linear Mode
