| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-07-2009, 09:53 AM
| |||
| |||
Hi, I have no knowledge about electronics and need help for connecting my BOB, drivers and motors. The BOB is a MPDX-122 http://www.pmdx.com/Doc/PMDX-122_Manual_111.pdf Drivers: Gecko G203V https://www.geckodrive.com/upload/G2...V-7-MANUAL.pdf Motors: Keling Technology, Inc part number KL34H295-43-8B http://www.kelinginc.net/KL34H295-43-8B.pdf One of them will be connected parallel and the others unipolar on the motors there is 8 wires and most likely there are some of them that needs to be join together and after this witch one goes where. The wire that I’m thinking on using is a 20 gauge, 6 leads + a ground and it is shielded is this the right wire The last thing I want is to blow some smoke and this is why I’m asking for help Thank you  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Connecting bipolar motors to a unipolar controller | tommee10533 | Controller & Computer Solutions | 1 | 05-04-2009 10:30 AM |
| Connecting two identical drivers to drive one stepper motor? | uplb | Stepper Motors and Drives | 2 | 11-24-2008 09:13 AM |
| Connecting bipolar motors without knowing which wire is which? | Witsenburg | Stepper Motors and Drives | 1 | 05-12-2007 10:29 AM |
| Using printer motors and drivers | NeoMoses | General Electronics Discussion | 16 | 04-07-2007 07:42 PM |
| Help with motors\drivers | wired | DIY-CNC Router Table Machines | 1 | 01-03-2005 11:17 AM |
| | |
Linear Mode
