| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
03-02-2005, 08:09 PM
| |||
| |||
Well it is time to assembly all the electronics for my cnc mill. I was planning on putting everything in one panel as listed below: 1. servo power supply 2. gecko drives w/heat sink 3. Bob Campbell breakout board 4. Bob Campbell speed control board 5. GS2 VFD 6. Motherboard and related computer peripherals. 7. Remaining odds and ends. Question I have is: Do I need to be concerned about noise (EMF, etc.) from the geckos or the servo power supply interfering with the computer, since the plan is to mount them near each other? I certainly don't want to do something that is a big no no. Chris  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G-Code to DXF | WayneHill | OpenSource Software | 200 | 04-22-2012 09:51 PM |
| Stepper control software suggestions | jlawren6 | General CAM Discussion | 6 | 05-21-2011 05:42 AM |
| Visual Basic Controller Project | dwwright | Visual Basic | 29 | 02-14-2011 01:24 PM |
| CNC Glossary | CNCadmin | CNCzone Club House | 17 | 03-09-2008 03:08 PM |
| HAAS Indexer Prodramming / Control | CAMmando | Haas Mills | 8 | 06-10-2003 10:22 AM |
| | |
Linear Mode
