Feedback 932 cnc milling machine

[Chompalot]

Has anyone got any info on this baby machine. I picked one up at Brighton Model World Exhibition.

there's a lead between the control box and the milling machine but just a 26 pin IDC plug as an input.

I would be greatful for any info



Cheers

Simon

[alunowe62]

I have only just joined this forum and was having a read of different topics when I stumbled on yours. Sorry this reply is a few years late but it may help someone else.

This was a small training unit used with the BBC computer. It had a control box with indicator LEDs on the front and a power supply and control circuits inside. A ribbon cable connected it to the table which had steppers for X, Y and Z axis as well as motor on/off control.
The other connector on the top went to the main bus connector on the BBC.
I still have one of these.

Programming was done in basic.

I'm not sure if I still have the manuals.

regards

Alun

[Red_Uk]

Hi all.

I've recently got myself a Feedback cnc 932, took me awhile to get it working, I've replaced the BBC cable with a Controller card and use it for basic engraving atm.

Have searched all over for info on this but there is not much around, so a manual or any other info/links on this machine would be great.

My machine came with a minicraft tool with it (MB 0520/D1) but I've since replace this with a proxxon, is the minicraft the original/optimal rotatary tool that came with the unit? as I estimate it is around 15-20 years old?

Any info is welcome

Red

[alunowe62]

Hi Red

I will pay a visit to my loft some time this week to look for the manuals (if they are still there).

Alun

[Red_Uk]

Ok thanks alunowe62.