Need Source for Cheap PS Filter Capacitors? - CNCzone.com-The Largest Machinist Community on the net!

Bird_E · #1 02-08-2005, 10:46 AM

Does any one know of a good source for inexpensive Power Supply Filter caps.
40,000uf @ 50Volts min. 75Volts would be nice?

Digikey seems pretty expensive.
Thanks!
Bob

ViperTX · #2 02-08-2005, 10:50 AM

I got mine at mouser.com 47,000 uf at 75 VDC for $38.00. They are Sprague, brand new and very good caps.

TinkerDJ · #3 02-08-2005, 12:29 PM

Keep on eye on ebay, seems to be the cheapest. Or some of the surplus electronic places.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PIC Open source Servo Driver Schematics development?	Rossz	Open Source Controller Boards	90	10-26-2011 03:37 PM
Any ideas for open source CAM package?	galacticroot	OpenSource Software	26	10-22-2007 11:35 AM
Open Source CNC Controller Specification	gregmary	DIY-CNC Router Table Machines	28	12-04-2005 09:58 PM
Power Supply Capacitors?	jevs	General Electronics Discussion	12	03-31-2005 02:23 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)