Varistor for Anilam Crusader M

[schmepe]

I am needing to order some new varistors for my Anilam Crusader M control. The varistors have 594 and 150V printed on them. I have searched out varistors (of the MOV type) and I am unsure how these are spec-ed out. If anyone knows of a specific varistor I need for this controller and where I could obtain a new one it will be much appreciated. I am attaching an image of the exact same type varistor that is still in good condition for identification.

Thanks
[IMG][/IMG]

[Quirky]

What is the diameter of the MOV? What voltage is normally across the MOV, and is this AC or DC? I probably have the ones you need on my shelf.

[andrew_miller@s]

Hey there,

are the MOV's accross the coil of the contactor? if so what is the coil voltage? and is the coil AC or DC? from this info I can provide you with a Digikey part number. MOV's are really cheap so I would replace all of the ones in your current setup.

How did you Know that the MOV was defective and also was any other controll circuitry damaged as well? I may have access to some Crusader components if you require them.

later,

Andrew.