| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-22-2009, 03:14 PM
| |||
| |||
I started a X-2 mini mill conversion over 2 years ago. Wife spent about 6 mo in the hospital and it went on the shelf. I have started on it again. I have 3 497oz motors and driver from Xylotex. I have all 3 mounted with 1 to 1 belt drive on the X and Y, and 2 to 1 on the Z. The motor on the X turns very hard and not smooth like the other 2. I took it off and it is the motor. I don't want to wire everything and the motor fry the board. Is there a way to check to see if the motor is junk??? I know basic electricity, but beyond that, I'm pretty dumb. THANKS Rodney  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A | guy2b1 | DIY-CNC Router Table Machines | 16 | 03-08-2011 05:50 AM |
| use satellite dish actuator motor as a stepper motor | ozni | Stepper Motors and Drives | 7 | 06-18-2010 07:55 PM |
| Stepper motor vs. Servo motor | Tony611 | General Electronics Discussion | 28 | 11-19-2008 08:11 AM |
| Beltdrive-stepper motor-stepper motor driver | Georg | Stepper Motors and Drives | 0 | 10-16-2007 04:56 PM |
| servos motor controled by stepper motor driver? | mike10 | Servo Motors and Drives | 1 | 01-03-2005 05:05 PM |
| | |
Linear Mode
