Please suggest an encoder - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
Please suggest an encoder

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

05-04-2009, 07:37 PM

Join Date: Nov 2003

Location: manitoba, canada

Posts: 350

Please suggest an encoder

permalink

cheap preferably. Looking at plugging it into this:

http://www.cnc4pc.com/Store/osc/prod...products_id=45

I am running an Xylotex setup with 400 oz in motors on a large wood router. the motors are double shafted, but I will also plan on installing counter dampeners like some people have made onto the motors to reduce the resonant frequency issue.

Thanks for the help.

ps. any suggestions on a convenient way to run encoders & dampeners on the same shaft are also welcome

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Would you suggest Visualmill?	matur61	Visual Mill	4	01-04-2009 03:43 AM
Can someone suggest a CAD/CAM?	jimluu	General CAM Discussion	4	04-28-2008 02:00 PM
Suggest a VFD	bcromwell	Phase Converters and VFD	1	04-20-2007 10:11 PM
Suggest some software! Please	disinformation	General CNC (Mill and Lathe) Control Software (NC)	2	01-13-2006 03:16 AM
Can any suggest	CNCadmin	CNC Wire Foam Cutter Machines	4	04-06-2004 10:23 PM

All times are GMT -5. The time now is 11:19 PM.