| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-08-2005, 01:01 PM
| |||
| |||
Hi all I am a newbie here at cnc and need some help. So far I have built the running gear for my router. I have also built the circuit boards from Geoff Williams build your own workshop bot. I do not have the motors at the moment but every thing is set up ready in an old pc. What I want to do is to test the boards without the motors. I have Kcam installed. Can this be done? Please note I haven’t got a clue about electronics.  |
|
#2
11-22-2007, 04:07 PM
| |||
| |||
| Hi bob a job, I have just finished my first driver board from the book by Geoff Williams, and am about to test it, but the book is a little lacking on saying anything about how to connect everything together and the jumper settings, do you have how you set it up please? Tony |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Testing for drive enable? | murphy625 | CamSoft Products | 5 | 04-06-2005 04:04 PM |
| Using a large drive on small motor? | murphy625 | General Electronics Discussion | 0 | 03-11-2005 04:23 PM |
| help with boards | mocnc | General Electronics Discussion | 15 | 02-17-2005 08:18 PM |
| Good DC motor and drive | JRoque | General Electronics Discussion | 11 | 01-02-2005 09:38 PM |
| question about 2 X 2axis boards | Stevie | General Electronics Discussion | 5 | 03-14-2004 06:39 PM |
| | |
Linear Mode
