| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#3
01-06-2005, 05:50 PM
| ||||
| ||||
| What type of drivers? A lot of times you don't need anything but a printer cable. The Xylotex board plugs right in with the included cable. Some drives require a power supply, too.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#4
01-06-2005, 06:52 PM
| |||
| |||
| I'll probably be using 201's. Before posting my question, I was under the impression that there was a piece of hardware that went between the pc and the driver, but after doing some research, it seems that in most cases, you just wire from the pc port to the driver. Am I on the right track here? John |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with LPT Stepper Interface | nickleplated | Stepper Motors and Drives | 5 | 06-08-2005 07:28 PM |
| Operator Interface Blues... | murphy625 | CamSoft Products | 11 | 03-31-2005 07:07 PM |
| 4 Channel Stepper Driver Which One! | dewayne | General Electronics Discussion | 2 | 07-08-2004 09:47 PM |
| Fun with floppy stepper and driver | Konstantin | General Electronics Discussion | 5 | 03-08-2004 01:18 AM |
| Selecting stepper driver components... | fyffe555 | General Electronics Discussion | 0 | 09-26-2003 09:50 AM |
| | |
Linear Mode
