| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-08-2009, 07:38 AM
| |||
| |||
Hi! I'm quite new to cnc but I've just received my components that I've ordered... Is it possible to advise me how I can connect my components? I've added an image from what I have up till now. The white cable comes from the 220V net, is it connected right? Thanks in advance! Kind regards  |
|
#3
03-09-2009, 05:49 PM
| |||
| |||
Well I hope I didn't do anything wrong yet :s Cause that's certainly not the way to connect your board. After a few mails with someone that speaks dutch to I made this scheme. Maybe it can be of use to someone else that uses an nc-step PCB Kind regards Pieter van Stee |
|
#4
03-12-2009, 03:05 AM
| |||
| |||
| Ok everything works now, just some software settings. So the schematics I posted earlier works excellent. If you need it, use it kind regards Pieter |
|
| Tags |
| connection basic setup |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Basic elctrical connections | LaserImage | General Electronics Discussion | 1 | 07-21-2008 11:26 AM |
| Ideas on connections (3*50 pin) | epineh | General Electronics Discussion | 2 | 05-17-2007 02:30 AM |
| Encoder connections ? | Idealchip | Servo Motors and Drives | 12 | 07-17-2006 01:58 PM |
| Pin connections for DNC to 4020 | Fudd | Fadal | 5 | 04-04-2006 02:40 PM |
| 201 connections | rickwinters | Gecko Drives | 0 | 01-15-2005 01:37 PM |
| | |
Basic cable connections 
Linear Mode
