| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-07-2009, 08:12 PM
| |||
| |||
Hello everyone Maybe someone here can help me. I need to come up with a easy to build, and interface (mach2/3) Spindle tach. I have converted my X3 to belt drive and a vfd. The digital to analog output board that I built for control of the 0-10 volt reference (vfd ) is not linear. Off about 1000 rpm over the range. I can achive the top speed by adjusting the vfd but I would like to have a true rpm readout in mach. I was thinking of something optical. But I do not have a good place for the sloted wheel. Everything is vary tight spacing. Maybe I could sense off the black belt with white lettering?? Or the fan on top of the motor.. or the splinded spindle shaft. In anycase I thought I would pose the question here. Thanks in advance.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spindle speed and tach for MACH3 | chrispy | Mach Software (ArtSoft software) | 16 | 04-05-2008 08:25 AM |
| Need Help!- TACH GENERATOR | higgo | Mazak, Mitsubishi, Mazatrol | 0 | 03-10-2008 11:32 PM |
| Tach kit | mark c | General Electronics Discussion | 5 | 10-12-2007 04:50 PM |
| Tach vs encoder | N4NV | General CNC (Mill and Lathe) Control Software (NC) | 7 | 02-03-2007 04:12 PM |
| diy tach | swarfmacdaddy | General Electronics Discussion | 6 | 01-29-2006 11:57 AM |
| | |
Spindle Tach 
Linear Mode
