mixing motor drivers and pc components - CNCzone.com-The Largest Machinist Community on the net!

codevark · #1 02-18-2009, 07:13 PM

Is it recommended not to put motor drivers(geckoG540) and power supply(Keling 48volt 7amp) in with the PC thats controlling it with mach3. Is there some kind of electrical interference or something?

johnmac · #2 02-19-2009, 09:41 PM

I've seen pictures of computer main boards mounted in the same enclosure as the motor power supply and drivers. I decided to keep my computer separate so I can change or upgrade it easier, if needed.

John

codevark · #3 02-19-2009, 09:55 PM

Yeah thats what I think I am going to do also. Thanks for replying

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Motor Drivers???	jcbeck84	Stepper Motors and Drives	14	01-08-2009 09:33 AM
Stepper Motor with 2 Drivers ??!!?	Santa Fe Al	Stepper Motors and Drives	5	07-26-2008 08:40 AM
2 drivers for 1 motor possible?	Sanghera	Open Source Controller Boards	4	04-14-2005 02:43 PM
motor mixing and matching...	charleyy	DIY-CNC Router Table Machines	8	09-05-2004 11:32 PM
Cnc Motor Drivers	A. Shuford	DIY-CNC Router Table Machines	1	09-04-2004 09:26 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)