| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
02-18-2009, 06:18 AM
| ||||
| ||||
 |
|
#3
02-18-2009, 07:09 AM
| |||
| |||
| thanx Andy for the links. what do you think about the "C11 - Multifunction CNC Board" http://www.cnc4pc.com/Store/osc/prod...products_id=46 |
|
#4
02-18-2009, 08:46 AM
| ||||
| ||||
| I used a different speed control board from them. Not built in. I worked, but with my motor controller for my treadmill motor, I kept getting some loping in the motor either at high speed or low speed depending on the Mach settings. I wound up using the smaller controller from Homann Designs. They work very well. Very small too. I use them on my lathe and my mill. The part you mentioned though looks like a good option. Nice to have all that onboard.
__________________ Lee Last edited by LeeWay; 02-18-2009 at 09:03 AM. |
|
#5
02-18-2009, 08:57 AM
| ||||
| ||||
| Be very careful with a BOB integrated speed control. If you connect it wrong or do not isolate with separate power supply, you can blow the whole BOB. What machine are you going to use this on? CR. |
| Sponsored Links |
| |
|
#6
02-19-2009, 01:12 AM
| ||||
| ||||
| Hi George The C11 Board looks good, thats the board I will look to buy when I upgrade to a HF spindle, at the moment I use the C10 board which I have had no problems with at all. Andy |
|
#7
02-19-2009, 01:35 PM
| |||
| |||
| I have a brand-new, never been used C11. I ended up going with a Gecko G540 and don't need a separate bob. If you are interested send me a pm. Since it's never been used, I'd like to get about $115 plus shipping, but make me an offer... Gary |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Breakout board to control Mach3 | Mongkol | General Electronics Discussion | 1 | 04-19-2008 12:38 PM |
| CNC4PC C10 Breakout Board and C6 Speed Controller ? dont want to fry it | maxboostbusa | Benchtop Machines | 2 | 01-24-2008 04:33 PM |
| Router Speed Control + Mach3 + Breakout Board | Dingo745 | General Electronics Discussion | 7 | 06-19-2007 08:58 PM |
| BPSeriesI / Centroid control- Spindle speed all out of whack with speed dial? | peter.blais | Bridgeport and Hardinge Mills | 9 | 08-08-2006 03:29 AM |
| Control panel w/ Gecko 202, Campbell breakout board | Norsksea | General Electronics Discussion | 0 | 01-27-2006 06:16 PM |
| | |
Linear Mode
