| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-11-2009, 12:12 PM
| |||
| |||
Hi, I would like to know if a PC Power supply would provide enough power to drive the MM2001 Interface board plus 4 12v 0.6A stepper motors and the hot wire for my foam cutter? The PC Power suply has a rating of 8 amp on the 12 volt rail. the output is indicated as 200w please give me your advice Thanks  |
|
#2
02-11-2009, 12:33 PM
| |||
| |||
| read this must find something there..but for chauffle i dont think so.. http://www.teaser.fr/~abrea/cncnet/e...1/faq_mm.phtml http://www.teaser.fr/~abrea/cncnet/l.../reglage.phtml http://www.teaser.fr/~abrea/cncnet/l...rs/chauffe.zip |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How'd you supply your power supply? | cnczane | DIY-CNC Router Table Machines | 12 | 08-28-2011 05:13 AM |
| Power supply help.... | sweFredrik | Stepper Motors and Drives | 2 | 11-24-2007 11:21 AM |
| More power from switching power supply | R.thayer | General Electronics Discussion | 4 | 03-10-2007 07:03 PM |
| Power Supply from a computer power supply | jmytyk | General Electronics Discussion | 21 | 01-11-2006 02:56 PM |
| DIY Power supply | mjarus | Mechanical Calculations/Engineering Design | 4 | 12-10-2005 10:16 AM |
| | |
Linear Mode
