| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
11-26-2004, 10:01 AM
| |||
| |||
I'm going to start wiring my drive cabinet today and I was wondering if someone would look over my schematic and maybe point out any potential problems. I'm using gecko 201's and Bob Cambells breakout board along with Mach2 software. Since the breakout board doesn't connect to the disable pins on the geckos, should this be connected to spst switches are should I just not connect them at all. The zipped file has a dwg and a dwf of the same drawing. Any advice / commits?
__________________ Aspire, VCPro, PhotoVCarve, Cut3D, Mach3, Home built CnC.  |
|
#4
11-26-2004, 11:22 AM
| |||
| |||
| I'll post some pics when I'm done with the side panals and the wiring.
__________________ Aspire, VCPro, PhotoVCarve, Cut3D, Mach3, Home built CnC. Last edited by CRFultz; 11-27-2004 at 03:15 AM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Techno-Isel CNC router for sale? | Noah | Commercial CNC Wood Routers | 5 | 11-27-2008 10:12 PM |
| 2nd Generation CNC Router Design 32.5” X 14” X 6” | gregmary | DIY-CNC Router Table Machines | 9 | 03-24-2005 04:46 PM |
| buscht's cnc router | buscht | DIY-CNC Router Table Machines | 25 | 04-13-2004 11:43 AM |
| My first CNC router: 1.5 years building | hddjohns | DIY-CNC Router Table Machines | 2 | 04-03-2004 10:18 AM |
| Budget CNC Router | Blackhawk | DIY-CNC Router Table Machines | 24 | 02-21-2004 07:19 PM |
| | |
Linear Mode
