| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-24-2008, 07:50 AM
| |||
| |||
I am in the process of getting all of the necessary parts electrical parts together to finish my plasma cutter. I have a question about the power supplies. Since my servo motors are on the larger size 2 1125 oz motor http://kelinginc.net/KL34-180-90.pdf, 1 850 oz motor http://kelinginc.net/KL34-170-72.pdf , and 2 600 oz motors http://kelinginc.net/KL34-150-90.pdf, I figure I will need more than 1 power supply. My question is do I connect all of the commons Negatives together? What about the common negative form different voltages such as the regulated 5 volts dc and the 12 or 24 volts dc? Thanks for the information Steve  |
|
#3
11-25-2008, 10:15 AM
| ||||
| ||||
| In my setup I am running steppers, I have the supply to the motors (50VDC) separate from the lower voltage 5-12VDC supply for my limits and controls.
__________________ Deeds not words... VoltsAndBolts Alternative Power Forums http://www.voltsandboltsonline.com/ |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Supply Questions | DanC | General Electronics Discussion | 1 | 09-07-2006 05:41 PM |
| Pc power supply questions | roni21702 | General Electronics Discussion | 3 | 04-15-2006 01:58 PM |
| power supply questions | SJ781 | Gecko Drives | 2 | 04-26-2004 08:37 PM |
| | |
Linear Mode
