| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-04-2004, 08:00 AM
| |||
| |||
I just picked up 4 new surplus sanyo steppers type 103-845-1111. The only info that is printed on them is 4.2v 4.7a, and 1.8deg/step. They are 4wire bipolar motors. I'm having trouble figuring out what my stepper driver requirements are, and where I should look for an appropriate driver. I'm an extreme novice at the electronics end of this. I appreciate any help. Thanks. -Justin    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Beginner Troubleshooting and Building Considerations | coherent | FAQ of CNC Machine building | 3 | 11-10-2011 01:27 PM |
| Does anyone know of a controller board for synchronized stepper motors | Yellowbeard | Stepper Motors and Drives | 2 | 04-03-2005 11:06 PM |
| Looking for controller board for synchronized stepper motors | Yellowbeard | General Electronics Discussion | 0 | 04-02-2005 08:50 AM |
| what voltage? i'm confused.. Stepper motors + driver board from hobbycnc | Loterus | Hobbycnc (Products) | 8 | 01-26-2005 07:10 AM |
| Driver board for 4A + motors ? | xairflyer | DIY-CNC Router Table Machines | 5 | 02-04-2004 02:15 PM |
| | |
Linear Mode
