| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-06-2008, 08:43 PM
| |||
| |||
Hi Evryone, I'm new to this board but I have a question and hope someone can point me in the right direction, ok here goes I'm converting my geared head mill/drill over to cnc, I got some stepper motors and drivers and power supplies free from work and plan to use mach 3 to interface with a breakout board BUT the stepper drivers are microlynx 7 and I can't figure out what leads to wire to what from the driver to breakout board. I found the instructions for the driver online but still can't figure it out. Also not sure what to use for dip switch settings. Does anyone have any experience with these? Can anyone explain if I can use these? Thanks in advance. DJ  |
|
#2
10-08-2008, 06:58 PM
| |||
| |||
anyone.....anyone.....anyone...... buhler.....buhler  Seriously does anybody have any idea. I wrote to the controller company hoping to get some info worst case I sell them all on ebay and buy some geckos. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| lynx 85 | breazr | CNC Plasma and Waterjet Machines | 2 | 02-07-2011 03:02 PM |
| micro ATX power supply wiring question | ericdwilso | General Electronics Discussion | 5 | 07-02-2007 10:15 AM |
| Pc to Linatrol Lynx | JINDA | General CNC (Mill and Lathe) Control Software (NC) | 3 | 05-29-2007 08:10 AM |
| lynx 220 | wilko | Daewoo/Doosan | 1 | 02-02-2007 08:26 AM |
| DaeWoo Lynx 200 GL | fjd | Daewoo/Doosan | 5 | 10-29-2005 09:43 PM |
| | |
Linear Mode
