Newbie is this driver good - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
Newbie- is this driver good

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

10-03-2008, 03:22 AM

Join Date: May 2008

Location: turkey

Posts: 22

is this driver good

permalink

hello people i dont know anything about electronics i found this driver its very cheap and doesnt need breakout board , is this a good driver? thanks

http://www.cncgeeker.com/index.php?m...&products_id=1

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is this a good driver?	rapture	Open Source Controller Boards	3	02-18-2008 12:48 PM
Need Help!- Help selecting a good driver for my stepper motors	rapture	Stepper Motors and Drives	7	02-13-2008 06:52 PM
Anybody have a good L298 driver board ???	epineh	General Electronics Discussion	6	06-02-2007 12:00 AM
Good 3-Axis driver board ?	deleteallusers	DIY-CNC Router Table Machines	5	04-11-2007 10:59 AM
Good driver for Omron U75030VA-BS1 servomotor?	Vikketsi	Servo Motors and Drives	2	02-26-2005 02:53 PM

All times are GMT -5. The time now is 04:29 PM.