| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-17-2008, 01:12 PM
| |||
| |||
Hi all, I am wondering if anyone can help. I have been looking at Tachus 42's 3 axis board and the chopper supply below and I am a bit confused about some of the components. On the schematic, it shows 5 resistors in parallel (current setting) and on the left it says 'Parallel Value' and 'Current Amp', is it the total parallel value or the individual resistor value? and what is the wattage of these resistors? Also the what is the value and wattage of resistors R5, R4 also R18,R17 and R31, R30. Hope someone can help as I would like to build this chopper supply. Thanks, m1ck. Last edited by m1ck; 09-17-2008 at 03:52 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Machine Build- 3 or 4 axis board? | befreezen | DIY-CNC Router Table Machines | 3 | 02-23-2008 12:21 PM |
| Tach kit | mark c | General Electronics Discussion | 5 | 10-12-2007 04:50 PM |
| Can I hook up a 3-axis board to a 1-axis board ? | Redline | Xylotex | 7 | 02-09-2007 09:45 PM |
| diy tach | swarfmacdaddy | General Electronics Discussion | 6 | 01-29-2006 11:57 AM |
| 3 axis board | extreme | Open Source Controller Boards | 24 | 06-12-2005 04:08 PM |
| | |
Tachus 42's 3 axis board. 
Linear Mode
