fanuc transformer - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
fanuc transformer

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

09-15-2008, 04:20 PM

keithmech

Join Date: Nov 2006

Location: canada

Posts: 65

fanuc transformer

permalink

I have a fanuc pertronics ABOL-0001 transformer.This is a multi-tap 3 phase unit.I have no schematic of this transformer and want to connect it .
the input taps ar 275/230/190/0 volts and the out put is 90.Any ideas?

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
One big transformer or three?	koslaz	General Electronics Discussion	4	10-13-2006 07:06 PM
transformer from UPS?	slp_prlzys	General Electronics Discussion	13	01-13-2006 01:30 PM
Is this transformer big enough?	bgolash	General Electronics Discussion	4	07-06-2005 10:39 PM
hot transformer	smarbaga	General Electronics Discussion	22	06-23-2005 07:53 AM
transformer hum	kra	General Electronics Discussion	4	02-11-2005 02:58 PM

All times are GMT -5. The time now is 09:37 PM.