| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-27-2008, 10:34 AM
| |||
| |||
First of all I hope I'm in the correct forum, if not will some redirect me to the correct place. I just installed a new driver on my CNC machine and have set most of the peramiters I need. My old driver died so I can not retrieve any info from it. The part I'm have a hard time finding is amount of Hz it takes to get a certain rpm. I have a 3hp 3 phase Elte spindle and want to run it at 1800rpm how many hz do I need to achieve this speed? Is there a chart somewhere that shows x Hz imput gives you x rpm output? Thanks, Eric Last edited by 1enick72; 08-27-2008 at 05:20 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where is M30 setting? | Rico55 | Machines running Mach Software | 1 | 05-10-2008 11:18 AM |
| Setting up EMC | rmacster | LinuxCNC (formerly EMC2) | 5 | 10-17-2007 08:47 AM |
| single axis driver and a b.o.b.,or multi-axis driver board | .xXACEXx. | Stepper Motors and Drives | 3 | 07-02-2007 11:13 PM |
| Servo motor specs. and driver setting questions. | southernexplore | Servo Motors and Drives | 1 | 08-04-2006 07:21 AM |
| Setting Zero | wjbzone | TurboCNC | 7 | 01-03-2004 04:25 PM |
| | |
Linear Mode
