| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-26-2008, 08:39 PM
| ||||
| ||||
I read that the hard drive will fail if mounted in a cabinet on the machine. Why?Is this from vibration?Could the hard drive be mounted in some sort of dampening device or is it better to go with a usb boot ?I have not had a problem yet but.  |
|
#2
08-26-2008, 09:06 PM
| ||||
| ||||
| They could and do fail just sitting on a desktop too. I have had several of them running on the same base as the machine with no trouble. I guess if the machine bounced around alot, it wouldn't be good, but I haven't seen failure due to any vibrations. If you want to be on the safe side, just stick some rubber feet under the cabinet that houses the electronics. Probably a good idea anyway.
__________________ Lee |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| anilam 3300 mk hard drive died | nealg | General CNC (Mill and Lathe) Control Software (NC) | 5 | 11-19-2010 11:50 AM |
| Does anyone backup their CNC's PC hard drive? | WayneHill | General CNC (Mill and Lathe) Control Software (NC) | 7 | 08-22-2010 09:14 PM |
| ??? For Hard Drive Users | Moparmatty | Haas Mills | 0 | 03-25-2008 06:51 AM |
| Hard Drive | larry53 | Computers and Networking | 5 | 01-04-2008 03:19 PM |
| Hard drive servo spindle are any good for home made lathe? | patriciooholegu | Servo Motors and Drives | 5 | 12-08-2007 09:48 AM |
| | |
Linear Mode
