| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-07-2008, 08:25 AM
| |||
| |||
i have a westamp servo board i bought via ebay to replace a bad one in my cnc turret mill. it is about 3 years older than the oem board which was also westamp. it came from a balancing machine, i am currently waiting for info from the seller on what type of servo motor was driven by it. i have their electrical schematic for the board, the pinouts look identical, even the pins used by the balance machine are the same used by my mill, with the exception of the balancing machine using the tach and my mill does not. what are the chances of this board being plug and play? my cnc tech is camping for a couple weeks and id like to get to work. maybe a better question, can i chance putting this board in and firing up the mill to see if it will run, or am i risking frying something? thanks!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Westamp servo board pinout help | metlcutr55 | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 07-01-2008 10:50 AM |
| Need help on Servo Dynamics board SDFP1525-17 | Twil759 | General CNC (Mill and Lathe) Control Software (NC) | 0 | 11-28-2007 11:33 AM |
| Servo Controller BOard | venomx999 | Servo Motors and Drives | 1 | 12-27-2006 12:37 PM |
| Servo Board Failures | CNC_Newbi | Servo Motors and Drives | 7 | 06-15-2006 09:07 PM |
| CNC newbie question Servo+driver+breakout board? | wolfmetalfab | Servo Drives | 0 | 05-11-2006 01:43 AM |
| | |
Linear Mode
