| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-30-2008, 01:16 PM
| |||
| |||
hey folks, a newbie here at PCB designing would like some help, i've been learning eagle software and doing lots of reading on the topic, i've added a schematic based on the ucn5804b chip for you pros out the to critique/give constructive critism on to help me know where i'm going wrong, so far one little thing that baffles me is that i'm not sure where the +5v on the chip connect to and if each chip has to connect to it's own seperate pin on the DB25 connector or if they can be joined like i have it in the schematic to one pin, please go a little easy on me, it's my first 3 axis board attemp and i have very little eletronic layout skills, take a look:  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Top view layout | Andre' B | Industrial Hobbies (Support forum) | 11 | 03-18-2008 01:51 AM |
| How do i layout an assembly? | genexis | Solidworks | 1 | 06-22-2007 09:44 AM |
| Layout Dye | mjarus | General Metalwork Discussion | 5 | 12-30-2005 11:06 PM |
| Looking for comments on this layout | wired | General Electronics Discussion | 17 | 02-18-2005 01:24 PM |
| | |
Linear Mode
