| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-29-2008, 01:40 PM
| |||
| |||
Wiring up my new KL-8078 I noticed I'm showing a weak electrical connection (testing without any power using a continuity tester) between the 45 volt positive and negative terminals, when I attach the wires I'll be using to supply power to them. This condition doesn't exist with the KL-5060's. Is this normal?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Life is too short | CNCRob | CNCzone Club House | 11 | 02-21-2009 09:56 PM |
| Keling driver 8078 | chicobee | Stepper Motors and Drives | 1 | 06-08-2007 01:36 PM |
| A short cut is not always the best way! | planescott | Mach Software (ArtSoft software) | 4 | 03-12-2006 08:58 PM |
| Need someone with CNC plasma for short run! | MrHorsepower | Employment Opportunity | 3 | 11-30-2005 05:02 PM |
| Short G1 ignored in ver 14.7 CNC Pro | HuFlungDung | CamSoft Products | 6 | 10-13-2005 10:05 AM |
| | |
Linear Mode
