| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-22-2008, 03:00 PM
| |||
| |||
Folks, My Stepper motor does not run in the CW direction I am having NEMA 23 stepper motor connected to my Univelop 4 Axis controller/Driver. It uses DB25 pin and I am using KCam. Any clues please .....  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Univelop stepper Drive Vs KCam - Issue | r0m3sh | CNCzone Club House | 0 | 04-22-2008 02:55 PM |
| VMC1000 Drive Engagment Issue | Millman1000 | Bridgeport and Hardinge Mills | 3 | 03-28-2008 07:48 AM |
| Fanuc Drive Board issue | Joseph Souza | General CNC (Mill and Lathe) Control Software (NC) | 1 | 09-09-2007 01:53 PM |
| Stepper issue???? | CrashMasterKev | Stepper Motors and Drives | 13 | 12-06-2006 01:18 AM |
| Weird stepper issue... | WilliamD | Stepper Motors and Drives | 0 | 07-21-2006 11:11 AM |
| | |
Linear Mode
