| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-11-2008, 08:19 PM
| ||||
| ||||
I just connected by brand spanking new BOB and 203v geckos but I can't get the output LED to come on. I have a 5v power LED lit and my estop is wired and seems to work, I have a pin 10 LED for the estop lit. I'm running everthing with Mach 3 and it seems to see the estop just fine. HELP! Dan  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C11G, Gecko 203v and Mach 3...connect what where? | teamtexas | Gecko Drives | 16 | 12-03-2009 09:53 PM |
| Newest version of Mach3 Version 1.90.065 | turmite | Mach Mill | 3 | 01-26-2009 09:21 PM |
| C11G BOB and KBIC controller | xkbal | General Electronics Discussion | 3 | 10-23-2007 08:49 AM |
| The C11G with Microstep Driver 5056 | newla | Machines running Mach Software | 1 | 02-05-2007 08:46 AM |
| VCarve Pro Trial version 3.0: any newer version? | monte55 | Vectric | 2 | 12-11-2006 05:12 PM |
| | |
C11G version 5.4 BOB can't get any output LED. 
Linear Mode
