| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-11-2008, 06:26 PM
| |||
| |||
Hi gang, I bought a THK VLA actuator on ebay that came with a petit-SERVO drive model QT-OP3TH1. I found a datasheet that describes the connectors, but no mention of the pinouts. I was unable to find any more information on the THK technical support site (I did manage to download the control software). Anybody have a suggestion on where I might find more detailed information ? Thanks.  |
|
#2
03-11-2008, 08:33 PM
| |||
| |||
| A little more info ... Understanding the input power connector would be most usefull. There are 5 pins labeled ... R T E = Earth/Ground P N I also know that it is single phase 110V AC. Any insight into the other inputs would be appreciated. Thanks again. |
|
#3
03-14-2008, 08:33 AM
| |||
| |||
| In the hopes that this may help someone in the future. The R and T connections are the 110V AC in. The unit powers up now. All I have to figure out now is the pinouts for the RS232 interface and the commands to program this puppy. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| motor & controller wiring | cueshark | General Electronics Discussion | 2 | 04-28-2007 09:25 AM |
| Could use some help wiring up Stepper Motor and Controller... | cflanagan | General Electronics Discussion | 1 | 12-28-2006 09:18 AM |
| | |
Linear Mode
