| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
12-16-2007, 04:57 PM
| ||||
| ||||
| Accurite used to offer that option, But I believe it was the two axis strobed out on a parallel port, but I am not sure whether you can order it on current models. With serial, it would need a buffer to store the positions when requested/strobed by the host,and then read out. In any case, it would most likely be an ordered option on most DRO's. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| serial port | lamicron | Computers and Networking | 9 | 12-18-2007 10:42 AM |
| USB to serial port | stampman | Machine Problems, Solutions , Wireless DNC, serial port | 7 | 12-30-2006 01:17 PM |
| Need some help with Ethernet-to-serial | kingneutron | Computers and Networking | 9 | 11-29-2006 01:49 PM |
| Serial 9 pin to USB adapter | 2_jammer | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 03-20-2006 01:33 PM |
| Serial CNC Software? | Ian Cunningham | General CAM Discussion | 3 | 08-02-2005 08:18 AM |
| | |
Linear Mode
