Results 1 to 5 of 5

Thread: driver ?

  1. #1
    Registered morpheus's Avatar
    Join Date
    Jun 2004
    Location
    United States
    Posts
    6
    Downloads
    0
    Uploads
    0

    driver ?

    hey guys, I'm trying to get a test bed CNC plasma cutter going out of an old engraver (about 3' x 3'). It has 2 NEMA 34 steppers (specs of 2.5V dc and 4.6a per phase). Any recommendations on a driver ? We've read all kinds of stuff on the net from this company and that company ... it gets to be confusing after a while. thanks...

    - jack


  2. #2
    Registered
    Join Date
    Apr 2004
    Location
    usa
    Posts
    439
    Downloads
    0
    Uploads
    0
    Last edited by sendkeys; 09-06-2004 at 05:04 PM.


  3. #3
    Registered morpheus's Avatar
    Join Date
    Jun 2004
    Location
    United States
    Posts
    6
    Downloads
    0
    Uploads
    0
    well, the budget is as little as possible to do the job well

    which model xylotex and and which model hobbycnc ones are you refering to ?

    thanks


  4. #4
    Registered
    Join Date
    Apr 2004
    Location
    United States
    Posts
    100
    Downloads
    0
    Uploads
    0
    xylotex only have one drive(no other choice). Hobbycnc look for 3amp chop driver.


  • #5
    Registered morpheus's Avatar
    Join Date
    Jun 2004
    Location
    United States
    Posts
    6
    Downloads
    0
    Uploads
    0
    the xylotex board looks appealing but it couldn't control actuating the plasma cutter like I think some other boards can. is this a big deal to do seperately ?

    thanks.


  • Similar Threads

    1. PIC Open source Servo Driver Schematics development?
      By Rossz in forum Open Source Controller Boards
      Replies: 90
      Last Post: 10-26-2011, 04:37 PM
    2. Good driver for Omron U75030VA-BS1 servomotor?
      By Vikketsi in forum Servo Motors and Drives
      Replies: 2
      Last Post: 02-26-2005, 03:53 PM
    3. servos motor controled by stepper motor driver?
      By mike10 in forum Servo Motors and Drives
      Replies: 1
      Last Post: 01-03-2005, 06:05 PM
    4. 4 Channel Stepper Driver Which One!
      By dewayne in forum General Electronics Discussion
      Replies: 2
      Last Post: 07-08-2004, 10:47 PM
    5. Fun with floppy stepper and driver
      By Konstantin in forum General Electronics Discussion
      Replies: 5
      Last Post: 03-08-2004, 02:18 AM

    Posting Permissions


     


    About CNCzone.com

      We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

    Follow us on

    Facebook Dribbble RSS Feed


    Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.