| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-27-2007, 10:56 PM
| |||
| |||
I bought a non working Wells Index mill with a Bandit control and want to use a PC to run it. The Bandit is not working and the seller knows that the stepper motors are good but one of the driver/translators is bad too. The cheapest way to get up and running would be to buy a drive and reuse the 2 good ones. The question is will a breakout board work with my Summit/Dana 8085 drivers and if not is there something I can interface the two together? The wires to the drive from the Bandit are marked GRD, DIR, PULSE, and FREE. The only comments in the manual about the 4 terminals are, DIR= (high/low) and PULSE= (normally high (12v) low to step). Thanks for reading Bob  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bandit/Summit driver question | bbowers | Bridgeport and Hardinge Mills | 2 | 11-27-2007 10:24 PM |
| Stepper driver question ? | msnarouz | Stepper Motors and Drives | 0 | 10-29-2006 08:16 AM |
| M6R5 driver question | Bill Davis | Stepper Motors and Drives | 1 | 02-17-2006 06:03 PM |
| Kasuga mill with Summit Dana control | Bob fran | General Metal Working Machines | 7 | 10-02-2004 01:52 AM |
| | |
Linear Mode
