| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-11-2007, 08:48 PM
| |||
| |||
Hi, I have a gear cutting machine that has about 30 change gears capable of creating well over one hundred different ratios. I was wondering if it would be difficult to build an NC controlled gear box? If I put a rotary encoder on the current input shaft - could a use a gecko or rutex drive to operate the output? What would be the easiest solution to multiply the input freq - microcontroller, plc, or pc? If anybody has any hints or ebay solutions on building something like this - I'd appreciate any advice. Thanks, Dan    |
|
#2
11-11-2007, 10:27 PM
| ||||
| ||||
| There is a gentleman that is building an Electronic Leadscrew that you might want to checkout. I have no connection with him other than I belong to the group. http://tech.groups.yahoo.com/group/E-LeadScrew/messages Alan
__________________ http://www.alansmachineworks.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| electrical ,electronic | shawnmor | General Electronics Discussion | 1 | 10-18-2007 07:40 AM |
| Another Electronic Ploblem | Smackre | General Electronics Discussion | 14 | 12-08-2006 11:17 PM |
| Spur Gear / Gear Rack | ckrantz | Linear and Rotary Motion | 12 | 12-07-2006 12:06 AM |
| I need an electronic guru.... | turmite | General Electronics Discussion | 9 | 01-12-2005 03:01 PM |
| Basic Bevel Gear - Milling a valley for gear teeth | ngr1 | General CAM Discussion | 9 | 04-17-2004 04:58 PM |
| | |
Linear Mode
