Need a tach sensor to Interface with Mach 3 - CNCzone.com-The Largest Machinist Community on the net!

dneisler · #1 11-03-2007, 05:17 PM

I have tried building the Shumatech tach addon but I cannot get it to function correctly. Is there one that is already made that I can buy....?

GrahamIT · #2 11-26-2007, 05:38 PM

You could always try a 3 channel quadrature encoder, the third channel is the index pulse and I think Mach3 can use it for showing RPM.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ShumaTech Tach Addon Help	dneisler	General Electronics Discussion	1	10-22-2007 02:02 PM
Tach kit	mark c	General Electronics Discussion	5	10-12-2007 05:50 PM
Tach vs encoder	N4NV	General CNC (Mill and Lathe) Control Software (NC)	7	02-03-2007 05:12 PM
diy tach	swarfmacdaddy	General Electronics Discussion	6	01-29-2006 12:57 PM
Cheap tach	Zephrant	General Electronics Discussion	1	06-05-2003 03:11 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)