| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-30-2007, 12:53 AM
| |||
| |||
I have drawn a circuit to drive a stepper. I intend on using a parallel port to step IR2184s which will drive the bridge fets.. I would be very suprised if this works;-) The schematic is HERE Any I had a problem setting trace widths on the brd. it's easy to set a net width but if I want part of a net narrow how do I go about that? I am going to use 100x160 mm double sided board, it doesn't look like there are many componets on the board yet the traces on the board looks so complicated.. Anyone have any tips on laying out components?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My DIY Stone Bridge Saw | DennisCNC | Glass, Plastic and Stone | 36 | 03-18-2010 09:54 PM |
| H-Bridge Bootstrap??? | acondit | General Electronics Discussion | 4 | 09-08-2007 09:29 PM |
| DIY H-bridge | medved | General Electronics Discussion | 13 | 03-22-2007 06:40 PM |
| bridge rectifier | osdhillon | General Electronics Discussion | 4 | 12-30-2005 09:24 AM |
| My new bridge | duluthboat | DIY-CNC Router Table Machines | 15 | 07-19-2004 11:58 AM |
| | |
Linear Mode
