Anyone familiar with NUM controls/drives/servos? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
Anyone familiar with NUM controls/drives/servos?

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

09-17-2007, 04:01 PM

Join Date: Feb 2007

Location: USA

Posts: 85

Anyone familiar with NUM controls/drives/servos?

I have a NUM servo drive on a KO Lee grinder kicking my ass.

Anyone work with these things?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Has any one used API Controls servo drives?	DennisCNC	Servo Motors and Drives	1	01-25-2006 10:32 PM
Anyone familiar with these Brushless Servos	Dave's_Not_Here	Servo Motors and Drives	23	06-05-2005 04:14 PM
Bridgeport servos with Gecko drives	GalaticDan	Servo Motors and Drives	0	03-17-2005 07:39 AM
Servos, steppers, drives and encoders, Oh my	MobilDave	Servo Motors and Drives	1	09-10-2004 07:04 AM
servos (encoders, drives)	gv71	General Electronics Discussion	3	03-31-2004 12:43 AM

All times are GMT -5. The time now is 09:01 PM.